Top Appliance Repair
    Repaired

    Whirlpool Washer Keeps Stopping With FL Code: Water Inlet Valve Replaced in San Francisco

    The washer kept stopping in the middle of a cycle and showing the FL code. The hot water inlet valve was not opening properly, so the washer could not fill in time and stopped with the FL (fill) error. The inlet valve assembly required replacement.

    Repair at a glance

    CitySan Francisco, CA
    ApplianceFront-load washer
    CategoryMajor Brands
    Brand & modelWhirlpool WFW8620HW3 front-load washer
    Repair date
    Customer complaintThe washer kept stopping in the middle of a cycle and showing the FL code.
    DiagnosisThe hot water inlet valve was not opening properly, so the washer could not fill in time and stopped with the FL (fill) error. The inlet valve assembly required replacement.
    Repair cost$396 (parts and labor)
    Warranty6 months on parts and labor
    OutcomeRepaired

    Checking the fill

    FL on this Whirlpool front loader means the washer did not see enough water within the expected time. I checked the door, the boot and the drum first, then ran a fill test. Cold water came in, but the hot side barely opened, so the control timed out and stopped the cycle.

    Valve replacement and test

    The inlet valve on this model comes as a pair, so I replaced both sections: W11036930, now supplied as W11688995, and W11036928, now supplied as W11688994. I reconnected the hoses and wiring, then ran hot, warm and cold fills.

    Both sides filled at a steady rate and the washer went through a full cycle without the FL code.

    Photos from this repair

    • Whirlpool WFW8620HW3 front-load washer in the laundry area.
      Whirlpool WFW8620HW3 front-load washer in the laundry area.
    • Door glass inspected before the fill test.
      Door glass inspected before the fill test.
    • Door boot and drum checked during the visit.
      Door boot and drum checked during the visit.
    • Checking the door boot folds for blockage.
      Checking the door boot folds for blockage.
    • Drum and boot condition before the inlet valve test.
      Drum and boot condition before the inlet valve test.

    Need Whirlpool front-load washer repair?

    $85 diagnostic applied to the repair. Serving San Jose, San Francisco & the Bay Area.