KitchenAid KEMC308KSS02 Microwave Door Error, Magnetron Replaced in San Jose
The microwave reported an open door, but the magnetron had shorted and blown the fuse. We pulled the unit, replaced the magnetron and the fuse, and tested heating.
Repair at a glance
| City | San Jose, CA |
|---|---|
| Appliance | Microwave |
| Category | Major Brands |
| Brand & model | KitchenAid KEMC308KSS02 |
| Repair date | |
| Customer complaint | The microwave did not work, kept beeping and said the door was open. |
| Diagnosis | Although the display showed a door error, the real fault was the magnetron. A short in the magnetron circuit blew the fuse and cut part of the power supply, which shows as a door error on these units. |
| Repair cost | $589 |
| Warranty | 6 months on parts and labor |
| Outcome | Repaired |
What the customer told us
The upper microwave on the KitchenAid KEMC308KSS02 combination unit beeped and showed that the door was open, and would not run.
What we found
The door switches were not the problem. The magnetron had shorted, which blew the fuse and removed power from part of the circuit; on these units that shows up as a door error.
How we repaired it
We ordered the magnetron, then pulled the combination unit out of the wall cabinet, opened the microwave section and replaced the magnetron and the fuse before reinstalling the unit.
Testing
The microwave ran without the door error and heated normally.
Photos from this repair

KitchenAid combination wall oven with the microwave on top. 
Microwave control panel before the repair. 
Model label on the frame. 
Microwave cavity. 
Unit pulled out of the cabinet onto the counter. 
Production label on the chassis. 
Magnetron in the microwave section. 
Wiring and control board inside the unit. 
Unit going back into the wall. 
Microwave display working after the repair.
Need KitchenAid microwave repair?
$85 diagnostic applied to the repair. Serving San Jose, San Francisco & the Bay Area.